● Surface coloring : Metal, plastic, cement, house, furniture, ornament.

● For repair painting : Wood, steel structure.

① Please remove dust, oil, rust, fungi, etc. on the coated face before spraying.

② Sufficiently shake the container upon use.

③ Spray at a distance of 30~40cm.

④ Apply thin overlap coating for 2~3 times at an interval of 10 minutes in parallel direction with

    the coated face as in the , rather than thick coating at one go.

⑤ When the contents remain after use, spray to allow only gas to come out for about 2 seconds

    by turning the container upside down, and properly cover the cap for storage.

※ Use after checking whether the color and the spray state are correct matching the use for

    the coated object prior to use.

※ Do not store inside a car or trunk during summer season. 

● Spray it after testing. (It can make negative effect depending on materials or properties of surface)

● To keep aerosol can unused for a long-time, hold it upside down and spray till no more liquid

    comes out to make a nozzle unblocked.

● Do not keep it inside of vehicles.

● Keep it away from children.

● Do not use it for other purposes.

● Use it at outdoor or a well-ventilated place.

● Do not spray directly onto human body, animal or food.

● As this is an inflammable product using high pressure gas, keep the following cautions carefully.

● Do not spray directly toward open flame.

● Do not use it near any heat sources such as radiators, heat registers, stoves, or other apparatus

   (including amplifiers) that produce heat.

● Do not use it in an environment where there are explosive or inflammable materials.

● Store the product in places where the temperature does not exceed 40℃.

● After used in enclosed areas, be sure to ventilate.

● Do not throw into a fire.

● After use, throw it away after checking and removal the remaining gas in the container.

● Do not store it in enclosed area.

● Below 5℃, injection power may be poor.