YECOA YL-107 realizes harmony between excellent cleaning power and swift evaporation

characteristics to display powerful cleaning by deeply penetrating into a complicated mold.

● Cleaning of injection molding residues from a mold and carbon

● Degreasing cleaning of all precision machines and metals

● Cleaning of fine and precise machines as well as aeronautic and electronic engineering instruments

● Cleaning and degreasing of all metal parts and apparatuses, etc. as well as removal of

    carbides and carbon residues of a mold upon injection molding

● Removal of gasket and paint, peeling of enamel, lacquer, varnish, epoxy resin, etc.

● Always wear safety equipment before work.

● Remove dust or dirt off applied surface to apply it.

● Use brush or sand paper to remove rust or scale and apply it.

● Spray twice or three times to make cleaning.

● Spray it about 20~30cm away from target object.

 ※ Please observe the following points when storing and using the product and discard.

● Even though it is low-flammable, keep away from fire to spray it.

● Provide good ventilation for long-time use.

● Keep it in the well-ventilated place below 40℃.

● Do not use it toward fire.

● Do not use near heater or stove.

● Do not use in the room using fire.

● Do not keep it in the place above 40℃.

● Provide ventilation to use it in the closed room.

● Do not throw it away into fire.

● Punch the can to throw it away.

● Do not keep it in the closed place.

● Spraying may not work well below 5℃.